Turning the Scan Station on and off

Adjusting the input and output trays

In most cases, the Scan Station will be powered on by turning the main power switch to the On position. If the Scan Station fails to start up, press the green Soft Start button.

Press the main power switch on the back of the Scan Station to the On (I) position.

Soft Start button

Main power switch

Wait for the Scan Station to complete the self-test. When completed, the green indicator on the Scan Station remains on and constant. The touch screen should also display the Scan Station application. If the Scan Station application fails to start up, press the green button.

To power-down the Scan Station, press the green Soft Start button. The Scan Station will go through a shutdown sequence. The Scan Station will still display the number 0 and the green LED will blink. To finish powering down the Scan Station, press the main power switch to the Off (O) position.

NOTE: If the Scan Station fails to shutdown using the above procedure, hold the green Soft Start button down for 5 seconds. This should only be used in extreme cases when the Scan Station fails to shutdown normally.

The input tray can be adjusted to fit different document sizes.

• Grasp the side guides and slide them to the desired position.

The output tray can be adjusted to accommodate documents longer than 11 inches (A4).

2-2

A-61544 January 2008

Page 15
Image 15
Kodak 100/120EX manual Soft Start button Main power switch