Kodak A-61097 manual Select Bar Code Type

Bar Code Type

Identifies the type of bar code which is to be read. The default value is

Code 39.

❏ Microimager 70	■	Microimager 70/AFM	■	Scanner 900
■ Scanner 923	■	Scanner/Microimager 990	■	Scanner 9500

1.Select Bar Code Type.

Mode Number: 10			Mode Name: MODE10
		Mode Configuration					Bar Code Reader
MODE 10	Mode Name		Ftswitch Pressed	Undef		Bar Code Reading Status
						Bar Code Type
3 Lvl	Index Format		Ftswitch Released	Undef
						# of Bar Code Characters
Supprs	IA Display Format		Ftswitch Cnf Tone	Off
						Bar Codes per Document
4233	IA Field Widths		Patch Reader 1	Off
2112	Level Rules		Patch Reader 2	Off	Distance Between Codes
						Scan Direction
None	Batching		Patch Definition	Lvl 2
						Image Processing
Auto	AEC Mode		Bar Code	Off
						Partial Read Enabled
Duplex	Film Mode		Confirmation Tone	N N N
?????	Reduction Ratio		OCR Status	Off		Min. Partial Characters
1 Roll	# of Cassettes		COIN User Channel	On		DSA Patch Reading Status
Comic	Film Writer		Printer Control	Disply
						Patch Horizontal Location
Off	Image Mgmt Code		Primary DP-1	Off
					End Fed Patch Read Status
Off	Length Monitor		Secondary DP-1	Off
						Level Change via Bar Code
Off	Skew Monitor		Doc. Printer 12	Off		Previous Menu
Xport	Check Stacker		Document Sorter	Off
Off	Endorser		Mode Overrides	No Sav
							Bar Code Type
	Not Used		Film Definition	F
						Code 39
						Interleaved 2/5
Save & End Session			Don't Save & End Session
						Codabar
	Previous Menu		End Configuration
						Previous Menu

2. Select the desired bar code type.

NOTE: Only one type of bar code may be read using a given mode. However, different modes may be defined as reading different types of bar code.

3-62 A-61097 May 1997