Kodak A-61097 manual Minimum Partial Characters, Select Min. Partial Characters

Minimum Partial Characters

NOTE: Partial Reading must be enabled or this definition will be ignored.

This mode defines the minimum number of characters which must be properly decoded to constitute a partial read. The default value is 5-80.

❏ Microimager 70	■	Microimager 70/AFM	■	Scanner 900
■ Scanner 923	■	Scanner/Microimager 990	■	Scanner 9500

1.Select Min. Partial Characters.

Mode Number: 10			Mode Name: MODE10
		Mode Configuration				Bar Code Reader
MODE 10	Mode Name		Ftswitch Pressed	Undef		Bar Code Reading Status
						Bar Code Type
3 Lvl	Index Format		Ftswitch Released	Undef
						# of Bar Code Characters
Supprs	IA Display Format		Ftswitch Cnf Tone	Off
						Bar Codes per Document
4233	IA Field Widths		Patch Reader 1	Off
						Distance Between Codes
2112	Level Rules		Patch Reader 2	Off
						Scan Direction
None	Batching		Patch Definition	Lvl 2
						Image Processing
Auto	AEC Mode		Bar Code	Off
						Partial Read Enabled
Duplex	Film Mode		Confirmation Tone	N N N
						Min. Partial Characters
?????	Reduction Ratio		OCR Status	Off
1 Roll	# of Cassettes		COIN User Channel	On		DSA Patch Reading Status
Comic	Film Writer		Printer Control	Disply		Patch Horizontal Location
Off	Image Mgmt Code		Primary DP-1	Off		End Fed Patch Read Status
Off	Length Monitor		Secondary DP-1	Off		Level Change via Bar Code
Off	Skew Monitor		Doc. Printer 12	Off		Previous Menu
Xport	Check Stacker		Document Sorter	Off
Off	Endorser		Mode Overrides	No Sav
	Not Used		Film Definition	F	Enter Minumum Length
					Range: 05 - 80 Characters
Save & End Session			Don't Save & End Session		05
	Previous Menu		End Configuration

2. Select the desired number of characters.

A-61097 May 1997 3-69