Konica Minolta C10P manual Solving Problems with Media Misfeeds, 116, Symptom Cause Solution

Solving Problems with Media Misfeeds

" Frequent misfeeds in any area indicate that area should be checked, repaired, or cleaned. Repeated misfeeds may also happen if you’re using unsupported print media.

Symptom	Cause	Solution
Several	The front edges of	Remove the media and even up the
sheets go	the media are not	front edges, then reload it.
through the	even.
printer
	The media is moist	Remove the moist media and replace it
together.
	from humidity.	with new, dry media.
	Too much static elec-	Do not fan transparencies.
	tricity is present.
Media mis-	Top cover needs to	Open and close the top cover of the
feed mes-	be opened and	printer again.
sage stays	closed again to reset
on.	the printer.
	Some media remains	Recheck the media path and make
	misfed in the printer.	sure that you have removed all of the
		misfed media.
Duplex	Unsupported media	Use KONICA MINOLTA-approved
option mis-	(wrong size, thick-	media. See “Media Specifications” on
feeds.	ness, type, etc.) is	page 50.
	being used.
		Plain paper, recycled paper, and letter
		head can be autoduplexed if the
		duplex option is installed and the
		media type is set properly in the driver.
		See “Media Specifications” on page
		50.
		Make sure that you have not mixed
		media types in Tray 1.
		Do not duplex envelopes, labels, trans-
		parencies, thick stock, postcard, or
		glossy stock.
	Media is still being	Recheck the media path inside the
	misfed.	duplex option and make sure that you
		have removed all of the misfed media.

116 Solving Problems with Media Misfeeds