Konica Minolta C10P manual 138, Dual In-Line Memory Module Dimm

2 Using a screwdriver, remove the screw on the back of the printer.

3 Remove the rear panel.

" Since there are two hooks on the right side of the panel, remove the rear panel by slightly pull- ing the left side of the panel toward you, then sliding the panel off to the left.

4 Insert the new DIMM straight into the DIMM connector until the latches snap into the locked position.

Observe the keyed side of the DIMM to align it with the connec- tor. If you cannot snap the DIMM into place, do not force it. Repo- sition it, making sure that the DIMM is seated completely in the connector.

5 Reinstall the panel and tighten the screw.

" If you removed the duplex option in step1, reinstall it.

138 Dual In-Line Memory Module (DIMM)