122
Effects
Overdrive, Amp models, and Mic models (OD Amp Mic)

b, f: Saturation [%]

With higher settings of this value, the waveform will change at

high gain levels, tending to cause distor tion. Lower settings of

this value will produce linear response.

c: Tube1 Bias

This expresses the effect that changes in vacuum tube bias have

on the distortion of the waveform. Higher settings of this value

will produce distortion even at low gain levels. Since this will

also change the overtone structure, you can use it to control the

tonal character.

d: Tube1 Phase

With the Wet Invert setting, the phase of the signal will be

inverted between stage 1 and stage 2. Since “Bias” is applied to

the inverted signal in stage 2, this will change the tonal character.

27: St. Tube PreAmp(Stereo Tube PreAmp Modeling)

This is a stereo vacuum tube preamp simulator (See “Tube Pre-

Amp Model (Tube PreAmp Modeling)” on page121.).

28: Mic Model+PreAmp(Mic Modeling + PreAmp)

This effect simulates a mic and vacuum tube preamp. You can

choose from various types of mic and posit ions to create differ-

ing sonic characters.

b: Mic Position

This expresses the effect that the mic position has on the sound.

The Close setting is the closest mic position, and the Far setting

is the farthest.

Mic/Pre Amp - Saturation
In
Out
Saturation = 0
Saturation = 50
Saturation = 100
Bias = 0
In
Out
Satulation = 50
Bias = 0
Bias = 50
Bias = 100
Mic/Pre Amp - Bias
aMic Type
Vintage
Dynamic, Multi
Condenser,
Percussion
Condenser,
Drums Dynamic,
Vocal Dynamic,
Multi Dynamic,
Vocal
Condenser,
Vocal Tube,
Kick Dynamic
Selects the type of mic
bMic Position Close, On, Off,
Far Sets the mic placement distance
c
Tube Low Cut
[Hz] Thru, 21...8.00k Sets the frequency of the low cut
filter
High Cut [Hz] 53...20.00k,
Thru
Sets the frequency of the high cut
filter
d
Tube Gain [dB] –24.0...+24.0 Sets the input gain to the vacuum
tube preamp
Saturation [%] 0...100 Sets the input/output response of
the preamp
e Tube Bias 0...100 Sets the bias level of the preamp
fTube Output
Level [dB] –48.0...+0.0 Sets the output level of the preamp
g
Wet/Dry Dry, 1:99...99:1,
Wet
Balance between the wet and dry
signal
Src Off...Tempo Table, “Dynamic Modulation
sources,” on page106
Amt –100...+100 Amount of modulation source
Left
Right
FX Amt
Output Level
FX Amt
Stereo In - Stereo Out
Tube Pre Amp1 Tube Pre Amp2
Tube Pre Amp1 Tube Pre Amp2
Left
Right
FX Amt
FX Amt
–
+
–
+
Invert
+Tube Pre AmpMic Simulation
Left
Right
FX Amt
Output Level
FX Amt
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out