50
Sound operating mode
Digital Drawbars page
Selected Effect
Non editable. This shows the effect assigned to the correspond-
ing FX processor. To select a different effect, see “Effects: “B” FX
Config” on page74.
Send
Use this knob to adjust the level of the dry sound sent to the cor-
responding effect.
Amount
Volume of the effect that is added to the dry (uneffected) signal.
Digital Drawbars page
DIGITAL DRAWBARS are different from ordinary Sounds.
Their parameters are not saved as a new Sound, but can be saved
to a Performance. Therefore, when entering the Digital Draw-
bars page, the MENU button is disabled.
Note: In Style Play and Backing Sequence mode, only a Digital
Drawbar Sound is avai lable for the Keyboard tr acks, and one for
the Style tracks. Save them to a Performance (see “Write Perfor-
mance dialog box” on page138 of the User’s Manual).
Note: In Song Play mode, there is a Digital Drawbars Sound for
the Keyboard tracks, one for Song tracks 1-8, another one for Song
tracks 9-16.
Note: In Sequencer mode there is a Digital Drawbars Sound for
Song tracks 1-8, one for Song tracks 9-16.
When you select the DIGITAL DRAWBARS bank, the Digital
Drawbar page appears, and the current setting is assigned to the
selected track.
When entering this page, the SLIDER MODE button is automat-
ically set to DRAWBARS, so you can use the sliders to change
each foot volume. As an alternative, touch a footage and drag it
on the display, or use the VALUE DIAL controls to change its
value.
Each foot refers to the pipe length in a pipe organ, in which the
sound is produced by pipes of different length. Longer pipes
mean a lower sound; therefore, the 16’ drawbar produces the
lowest pitched sound, while the 1’ drawbar produces the highest
pitched sound.

Percussion/Rotary tab

Percussion adds a percussive sound to the attack segment of the
organ sound. Rotary adds the effect of a rotating speaker.
On/Off
Use this parameter to turn percussion on or off.
Foot
Use this parameter to select a percussion register.
4’ Percussion added to the 4’ foot.
22/3’ Percussion added to the 22/3’ foot.
Mode (Percussion Mode)
This parameters lets you decide if the percussion sound has to be
triggered on the fi rst note of a group of held notes, or to a ll notes.
All The percussive attack is played on all notes of a
chord.
1st The percussive attack is played only on the first
note of a chord or a group of h eld notes. Release
all notes to trigger the percussion again.
Volume (P ercus sion Vo lume)
Level of the percussive sound.
0…99 Level.
Length (Percussion Length)
Decay speed of the percussive sound.
0…99 Decay time.
Rotor On/Brake
Touch this button to start or stop the rotating speaker.
Speed Slow/Fast
Touch this button to switch the rotating speaker’s speed (from
slow to fast, or vice-versa).
Note: The “Rotor On/Brake” and “Speed Slow/ Fast” parameters
are only available when a Rotary effect has been assigned to one of
the FX slots (effects #63 or #133).
Get Sliders
Touch this button to get the current position of the physical slid-
ers, and assign their value to the virtual slider.