144
Effects
Delay
67: St. Mod Delay(Stereo Modulation Delay)

This stereo delay uses an LFO to sweep the delay time. The pitch

also varies, creating a delay sound which swells and shimmers.

You can also control the delay time using a modulation source.

b: D-mod Modulation

When the modulation source is used for control, this parameter

reverses the left and right modulati on direction.

d: LFO Sync

d: Src

g: L LFO Phase [deg]

h: R LFO Phase [deg]

If “LFO Sync” is On, the LFO will be reset by the modulation

source that is received.

The “Src” parameter sets the modulation source that resets the

LFO. For example, you can assign Gate as a modulation source

so that the sweep always starts from the specified point.

“L LFO Phase” and “R LFO Phase” set the phase obtained when

the left and right LFOs are reset. In this way, you can create

changes in pitch sweep for the left and right chan nels individu-

ally.

The effect is off when a value of the modulation source specified in
the “Src” parameter is 63 or smaller, and the effect is on when the
value is 64 or higher. The LFO is triggered and reset to the “L LFO
Phase” and “R LFO Phase” settings when the value changes from 63
or smaller to 64 or higher.
68: St. Dynamic Delay(Stereo Dynamic Delay)

This stereo delay controls the level of delay according to the

input signal level. You can use this as a ducking delay that applies

delay to the sound only when you play keys at a high velocity or

only when the volume level is low.

aModulation
Mode LFO, D-mod
Switches between LFO modulation
control and modulation source
control
b
D-mod
Modulation
L/R:+/+,
L/R:+/–
Reversed L/R control by modulation
source
Src Off...Tempo Selects the modulation source that
controls delay time
Response 0...30 Sets the rate of response to the
modulation source
c
LFO Waveform Triangle, Sine Selects the LFO Waveform
LFO Shape –100...+100 Changes the curvature of the LFO
Waveform
d
LFO Sync Off, On Switches LFO reset off/on
Src Off...Tempo Selects the modulation source that
resets the LFO
eLFO Frequency
[Hz] 0.02...20.00 Sets the speed of the LFO
f
MIDI Sync Off, On
When this is on, the LFO speed is set
by BPM, Base Note, and Times,
instead of Frequency
BPM
MIDI,
40.00...
300.00
MIDI syncs to the system tempo; 40–
300 sets the tempo manually for this
individual effect
Base Note r...w Selects the type of notes that
specify the LFO speed
Times x1...x32 Sets the number of notes that
specify the LFO speed
g
L LFO Phase
[deg] –180...+180 Sets the phase obtained when the
left LFO is reset
L Depth 0...200 Sets the depth of the left LFO
modulation
h
R LFO Phase
[deg] –180...+180 Sets the phase obtained when the
right LFO is reset
R Depth 0...200 Sets the depth of the right LFO
modulation
i
L Delay Time
[msec] 0.0...1000.0 Sets the delay time for the left
channel
L Feedback –100...+100 Sets the feedback amount of left
delay
j
R Delay Time
[msec] 0.0...1000.0 Sets the delay time for the right
channel
R Feedback –100...+100 Sets the feedback amount of right
delay
k
Wet/Dry
-Wet, -
1:99...Dry...99:1
, Wet
Balance between the wet and dry
signal
Src Off...Tempo Table, “Dynamic Modulation
sources,” on page106
Amt –100...+100 Amount of modulation source
Left
Right
Feedback
LFO Phase
FX Amt
FX Amt
Stereo In - Stereo Out
LFO: Tri / Sine
Modulation Mode
D-mod
LFO
D
-mod
Delay
Delay
L/R: +/+ +/–
LFO Shape
Response
LFO Sync
aControl Target None, Out, FB Selects from no control, output, and
feedback
Polarity +, – Reverses level control
bThreshold 0...100 Sets the level to which the effect is
applied
Offset 0...100 Sets the offset of level control
c Attack 1...100 Sets the attack time of level control
d Release 1...100 Sets the release time of level control
eL Delay Time
[msec] 0.0...1360.0 Sets the delay time for the left
channel
fR Delay Time
[msec] 0.0...1360.0 Sets the delay time for the right
channel
g Feedback –100...+100 Sets the feedback amount
h
High Damp [%] 0...100 Sets the damping amount in the
high range
Low Damp [%] 0...100 Sets the damping amount in the low
range
i Spread –100...+100
Sets the width of the stereo image
of the effect sound
j
Wet/Dry Dry, 1:99...99:1,
Wet
Balance between the wet and dry
signal
Src Off...Tempo Table, “Dynamic Modulation
sources,” on page106
Amt –100...+100 Amount of modulation source
Delay
Left
Right
Feedback Spread
FX Amt
FX Amt
Stereo In - Stereo Out
High DampLow Damp
High DampLow Damp
Threshold
Delay
FB Out
Control Target
Attack, Release
Envelope
+