Kyocera 2345 manual Door off, Phone, Door down, Removing the Battery, Charging the Battery

Removing the Battery

Before you remove the battery, make sure the phone is off. To remove your battery, follow these steps:

12

1. Hold the phone face down,	2. Lift the battery	3. Lift and slide
place your thumb in the	door off the	the battery out
groove on the back of the	phone.	of the phone.
phone and slide the battery
door down.

Charging the Battery

Your Sprint PCS Phone comes with a rechargeable Lilon battery, which is partially charged when you receive the phone. Fully charge the battery before using the phone.

￿Connect the AC Adapter to the proper connector

on the bottom of the phone as shown, then connect the adapter’s plug to a wall outlet.

Keeping track of your battery’s charge is important.

If your battery level becomes too low, your phone automatically turns off.

The battery charge indicator () is located in the upper-right corner of your phone’s display screen. If the battery charge gets too low, the indicator blinks and the phone sounds a warning tone.

Note: You must have at least a partial charge in the battery to make or receive calls, regardless of whether or not the AC Adapter is connected to the phone. The battery indicator is animated as the battery is charging.

The battery is fully charged when the battery indicator looks like . You can safely recharge the battery at any time, even if it has a partial charge.

Warning! Always use Sprint PCS approved battery chargers. Using the wrong charger could cause damage to your phone and void the warranty.

Section 2

Getting to Know Your Sprint PCS Phone