Lantronix 900-618 manual To enable the hostlist, Hostlist Option

	7: Setup Mode: Channel Configuration
Command String	Result if remote IP is 129.1.2.3 and remote port is
	1234
	Once it connects, the unit stops trying to connect to any others.
	If this connection fails, the unit continues to scroll through the
	table until it is able to connect to another IP in the hostlist.
	Hostlist supports a minimum of 1 and a maximum of 12 entries.
	Each entry contains the IP address and the port number.
	The hostlist is disabled for Manual and Modem Modes. The unit
	does not accept a data connection from a remote device when
	the hostlist option is enabled.

Figure 7-2. Hostlist Option

Baudrate (9600) ?

I/F Mode (4C) ?

Flow (00) ?

Port No (10001) ?

ConnectMode (C0) ? 25

Send '+++' in Modem Mode (Y) ?

Show IP addr after 'RING' (Y) ?

Auto increment source port (N) ?

Hostlist :

01.IP : 172.019.205.011 Port : 00001

02.IP : 172.019.205.012 Port : 00002

03.IP : 172.019.205.013 Port : 00003

Change Hostlist ? (N) ?

Hostlist Retrycounter (3) ?

Hostlist Retrytimeout (250) ?

DisConnMode (00) ?

FlushMode (00) ?

DisConnTime (00:00) ?:

SendChar 1 (00) ?

SendChar 2 (00) ?

To enable the hostlist:

1.Enter a Connect Mode of 0x20 (2X), where X is any digit. The menu shows you a list of current entries already defined in the product.

2.To delete, modify, or add an entry, select Yes. If you enter an IP address of 0.0.0.0, that entry and all others after it are deleted.

3.After completing the hostlist, repeat the previous step if necessary to edit the hostlist again.

4.For Retrycounter, enter the number of times the Lantronix unit should try to make a good network connection to a hostlist entry that it has successfully ARPed. The range is 1-15, with the default set to 3.

5.For Retrytimeout, enter the number of seconds the unit should wait before failing an attempted connection. The time is stored as units of milliseconds in the range of 10-65535. The default is 250.

xPico User Guide 46