7: Setup Mode: Channel Configuration
Y (Yes) auto increment the source port. The xPico increments the port number used
with each new connection.
Remote IP Address
This is the destination IP address used with an outgoing connection.
Remote IP Address : (000) (000) (000) (000)_
Note: This option does not display when Hostlist is enabled from the ConnectMo de
prompt (see Connect Mode on page 42 for more information).
Remote Port
You must set the remote TCP port number for the unit to make outgoing conn ections.
This parameter defines the port number on the target host to which a connec tion is
attempted.
Remote Port (0) ? _
To connect an ASCII terminal to a host using the unit for login purposes, us e the
remote port number 23 (Internet standard port number for Telnet services) .
Note: This option does not display when Hostlist is enabled from the ConnectMo de
prompt (see Connect Mode on page 42 for more information).
DisConnMode
This setting determines the conditions under which the unit will caus e a network
connection to terminate.
DisConnMode (00) ? _
Notes:
In DisConnMode (Disconnect Mode), Modem Control In drop either drops the
connection or is ignored.
All bit positions in the table that are blank represent “don’t care” bits, f or that
particular option, which can be set to either a 0 or 1 value.
Table 7-9. Disconnect Mode Options
Disconnect Mode Option
7
6
5
4
3
2
1
0
Disconnect when Modem Control In is not asserted
(6)
1
Ignore Modem Control In 0
Telnet Com Port Cntrl and terminal type setup (1) 1
Channel (port) password
(2)
1
Hard disconnect
(3)
0
Disable hard disconnect 1
xPico User Guide 50