7: Setup Mode: Channel Configuration
Modem Mode
Command
Function
ATD0.0.0.0 Forces the unit into Monitor Mode if a remote IP address and port
number are defined within the unit.
ATD or ATDT Forces the unit into Monitor Mode if a remote IP address and port
number are not defined within the unit.
ATDx.x.x.x Makes a connection to an IP address (x.x.x.x) and the remote port
number defined within the unit.
ATH Hangs up the connection (Entered as +++ATH ).
ATS0=n
Enables or disables connections from the network going to the serial
port.
n=0 disables the ability to make a connection from the network to the
serial port.
n=1-9 enables the ability to make a connection from the network to
the serial port.
n>1-9 is invalid.
ATEn
Enables or disables character echo and responses.
n=0 disables character echo and responses.
n=1 enables character echo and responses.
ATVn
Enables numeric response or full verbose.
n=0 enables numeric response.
n=1 enables full verbose.
Note: The unit recognizes these AT commands as single commands such as AT E0
or ATV1; it does not recognize compound commands such as ATE0V.
Send the Escape Sequence (+++) in Modem Mode Send ‘+++’ in Modem Mode (Y) ? _
Disable or enable the xPico’s ability to send the escape sequence. The default is Y
(Yes) (send the escape sequence).
Show IP addr after 'RING' Show IP addr after 'RING' (Y)
Disable or enable the xPico's ability to show the IP address after RING in Modem
Mode. The default is Y (Yes), to show the IP address.
Auto Increment Source Port Auto increment source port (N) ? _
xPico User Guide 49