7: Network, Line, Tunnel, and Terminal Settings

 

 

 

 

 

 

Tunnel –

Description

 

 

Accept Mode

 

 

 

Page Settings

 

 

 

TCP Keep Alive

Specify the number of milliseconds the EDS waits during an inactive

 

 

 

connection before checking the status of the connection. If the EDS

 

 

 

does not receive a response from the remote host, it drops that

 

 

 

connection.

 

 

 

 

 

 

Email on Connect

Select whether an email is sent when a connection is made.

 

 

 

None = do not send an email.

 

 

 

Email # = send an email corresponding to the tunnel number.

 

 

 

 

 

 

Email on

Select whether an email corresponding to the tunnel number is sent

 

 

Disconnect

when a connection is closed.

 

 

 

None = do not send an email.

 

 

 

Email # = send an email corresponding to the tunnel number.

 

 

 

 

 

 

Password

Enter a password that clients must send to the EDS within 30 seconds

 

 

 

from opening a network connection to enable data transmission.

 

 

 

The password can have up to 31 characters and must contain only

 

 

 

alphanumeric characters and punctuation. When set, the password sent

 

 

 

to the EDS must be terminated with one of the following: (a) 0x10 (LF),

 

 

 

(b) 0x00, (c) 0x13 0x10 (CR LF), or (d) 0x13 0x00.

 

 

 

 

 

 

Prompt for

Indicate whether the user should be prompted for the password upon

 

 

Password

connection.

 

 

 

On = prompt for a password upon connection.

 

 

 

Off = do not prompt for a password upon connection.

 

Tunnel – Connect Mode Page

Connect Mode determines how the EDS initiates a connection to a remote host or device. If you click Connect Mode at the top of one of the Tunnel pages, the Tunnel – Connect Mode page displays. Here you can select the method for starting a tunnel in Connect mode and select other settings for the tunnel selected at the top of the page.

Any configuration changes you make on the displayed page apply to the tunnel you selected at the top of this page. For example, if Tunnel 1 is selected, any configuration changes you make apply to tunnel 1.

Under Current Configuration, both Remote Address and Remote Port have a Delete link that lets you delete the remote address and port number shown. If you click this link, a message tells you that your action may stop an active connection. Click OK to proceed or Cancel to cancel the operation.

For more information about Connect mode, see Connect Mode on page 162.

EDS Device Servers User Guide

63

Page 63
Image 63
Lantronix EDS8PR, EDS32PR, EDS16PR, EDS4100 manual Tunnel Connect Mode