Lantronix EDS16PR, EDS32PR, EDS4100, EDS8PR manual Tunnel Connect Description Mode Settings, Udp

		7: Network, Line, Tunnel, and Terminal Settings
		Tunnel – Connect Mode Page
	Tunnel – Connect	Description
	Mode Page
	Settings
	Mode	Select the method to be used to start a connection to a remote host
		or device. Choices are:
		Disabled = an outgoing connection is never started. (default)
		Enabled = a connection is attempted until one is made. If the
		connection gets disconnected, the EDS retries until a connection is
		made.
		Any Character = a connection is started when any character is read
		on the serial line.
		Modem Control Asserted = a connection is attempted as long as the
		Modem Control pin (DSR) is asserted until a connection is made.
		Start Character = a connection is attempted when the start character
		for the selected tunnel is read on the serial line.
		Modem Emulation = a connection is started when triggered by
		modem emulation AT commands.
	Remote Address	Enter the address of the remote host to which the selected tunnel will
		connect. Default is <none>.
	Remote Port	Enter the number of the remote port to which the selected tunnel will
		connect. Default is <none>.
	Local Port	Enter the number of the local port that will participate in this tunnel.
		Default is Port 1 = 10001, Port 2 = 10002, Port 3 = 10002, and Port 4
		= 10004, and so forth.
	Protocol	Select the protocol to use on the connection. Choices are:
		TCP (default)
		UDP
		SSH = use this setting if security is a concern. This setting requires
		you to enter an SSH username.
		SSL
		Telnet
		TCP/AES = use for secure tunneling by means of TCP between two
		EDS devices or other devices that support AES.
		UDP/AES = use for secure tunneling by means of UDP between two
		EDS devices or other devices that support AES.
	Reconnect Timer	Enter the maximum number of milliseconds to wait before trying to
		reconnect to the remote host after a previous attempt failed or the
		connection was closed. Default is 15000 milliseconds.
	Flush Serial Data	Select whether to flush the serial line when a connection is made.
		Choices are:
		Enabled = flush the serial line when a connection is made.
		Disabled = do not flush the serial line. (default)
	SSH Username	If you selected SSH as the protocol for this tunnel, enter the SSH
		client user that is to be used for the SSH connection. Default is
		<none>.
EDS Device Servers User Guide		65