![](/images/new-backgrounds/1267697/267697121x1.webp)
MSS User Guide | 5: Using the MSS |
Figure 5-10: Back-to-Back MSS Connections
TCP Configuration
Assuming the MSS serial port parameters have been configured properly, the device servers are configured as follows for
MSS_A | Local>> CHANGE PORT 1 DEDICATED TCP 192.168.0.10:3001T |
| Local>> CHANGE PORT 1 AUTOSTART ENABLED |
MSS_B | Local>> CHANGE PORT 1 ACCESS REMOTE |
| Local>> CHANGE PORT 1 DEDICATED NONE |
| Local>> CHANGE PORT 1 AUTOSTART DISABLED |
Configuration for MSS100 is as follows: | |
MSS_A | Local>> CHANGE DEDICATED TCP 192.168.0.10:3001T |
| Local>> AUTOSTART ENABLED |
MSS_B | Local>> CHANGE ACCESS REMOTE |
| Local>> CHANGE DEDICATED NONE |
Local>> CHANGE AUTOSTART DISABLED
Note: If the device servers are on different IP subnets, the default gateway on each unit will have to be configured with the Change Server Gateway command.
The above commands create a raw
UDP Configuration
When the UDP protocol is used, there is no connection; each MSS must be told explicitly which hosts it is allowed to accept packets from. Each MSS would have to be configured to both send packets to and accept packets from the other MSS.
Configuration for
MSS_A Local>> CHANGE PORT 1 DEDICATED TCP 192.168.0.10:4096U Local>> CHANGE PORT 1 AUTOSTART ENABLED
Local>> CHANGE PORT 1 ACCESS DYNAMIC
MSS_B Local>> CHANGE PORT 1 DEDICATED TCP 192.168.0.13:4096U Local>> CHANGE PORT 1 AUTOSTART ENABLED
Local>> CHANGE PORT 1 ACCESS DYNAMIC
Configuration for MSS100 is as follows:
MSS_A Local>> CHANGE DEDICATED TCP 192.168.0.10:4096U
Local>> CHANGE AUTOSTART ENABLED
Local>> CHANGE ACCESS DYNAMIC
MSS_B Local>> CHANGE DEDICATED TCP 192.168.0.13:4096U
Local>> CHANGE AUTOSTART ENABLED
Local>> CHANGE ACCESS DYNAMIC