MSS User Guide | 4: Configuration |
The examples in Figure
| transmit packet |
The complete syntax of the Change Port [Portlist] Datasend command is described in the MSS Reference Manual.
Baud Rate
The MSS and attached serial device, such as a modem, must agree on a speed or baud rate to use for the serial connection. Valid baud rates for the
Figure 4-42: Changing the Baud Rate for MSS-VIA and MSS4
Local>> CHANGE PORT 1 SPEED 19200 
Figure 4-43: Changing the Baud Rate for MSS100
Local>> CHANGE SPEED 19200 
The MSS supports Autobaud, which allows the serial port to match its speed to the attached serial device upon connection (see Change Port Autobaud in the MSS Reference Manual for an explanation of the baud rate negotiation process). Autobaud is disabled by default, but can be enabled with the following command.
Figure 4-44: Enabling Autobaud for MSS-VIA and MSS4
Local>> CHANGE PORT 1 AUTOBAUD ENABLED
Figure 4-45: Enabling Autobaud for MSS100
Local>> CHANGE AUTOBAUD ENABLED
Character Size, Parity, and Stop Bits
The default character size of 8 data bits can be changed to 7 data bits. Similarly, the default stop bit count of 1 bit can be changed to 2 bits. Parity is normally None, but can also be Even, Mark, Odd, or Space. To change these parameters, use the following commands:
Figure 4-46: Configuring Serial Port Parameters for MSS-VIA and MSS4
Local>> CHANGE PORT 1 CHARSIZE 7
Local>> CHANGE PORT 1 STOPBITS 2
Local>> CHANGE PORT 1 PARITY EVEN
Figure 4-47: Configuring Serial Port Parameters for MSS100
Local>> CHANGE CHARSIZE 7
Local>> CHANGE STOPBITS 2
Local>> CHANGE PARITY EVEN
