Changing port settings after installing a newnetwork Internal Solutions Port
When a new network Lexmark Internal Solutions Port (ISP) is installed in the printer, the printer configurations on
computers that access the printer must be updated because the printer will be assigned a new IP address. All
computers that access the printer must be updated with this new IP address in order to print to it over the network.
Notes:
If the printer has a static IP address that will stay the same, then you do not need to make any changes to the
computer configurations.
If the computers are configured to print to the printer by a network name that will stay the same, instead of by
IP address, then you do not need to make any changes to the computer configurations.
If you are adding a wireless ISP to a printer previously configured for a wired connection, then make sure the
wired network is disconnected when you configure the printer to operate wirelessly. If the wired connection
remains connected, then the wireless configuration will complete, but the wireless ISP will not be active. This
can be fixed by disconnecting the wired connection, turning the printer off, and then turning the printer back
on again.
For Windows users
1Print a network setup page and make a note of the new IP address.
2Do one of the following:

In Windows Vista

aClick .
bClick Control Panel.
cUnder Hardware and Sound, click Printer.

In Windows XP

aClick Start.
bClick Printers and Faxes.

In Windows 2000

aClick Start.
bClick Settings Printers.
3Locate the printer that has changed.
Note: If there is more than one copy of the printer, then update all of them with the new IP address.
4Right-click the printer.
5Click Properties.
6Click the Ports tab.
7Locate the port in the list, and then select it.
8Click Configure Port.
Additional printer setup
56