Lorex 16 channel security NVR with PoE switch manual 176

Appendix B: Installing or Replacing the Hard Drive

Removing the Hard Drive

Make sure that the power cable has been disconnected before changing the hard drive.

To remove the hard drive:

1Remove the screws from the back (x2) and side panels.

2Remove the screws from each side panel (x3) and the top of the rear panel (x2) of the cover.

Side panel screws

Rear panel screws

Do not remove the other screws on the rear panel.

3Disconnect the power and data cables from the hard drive.

4Turn the NVR over and remove the 4 hard drive screws. Remove the hard drive from the system. Make sure to hold the hard drive in place while removing the screws to avoid damaging the NVR.

Remove the screws to remove the hard drive

5Turn the NVR back over and replace the cover. Replace the side panel and rear panel screws.

158