Event / Sensor

ALARM OUTBUZZER OUT

Sends an Alarm Out signal to a device (such

Generates a Buzzer when an alarm is

as a Manual Door or independent Light/

detected.

Buzzer Alarm) when an Alarm In event is

 

 

detected

 

 

 

•Channel - Indicates all channels.

•Operation - Setup Relay Connect with Alarm Sensor to either Enable or Disable. Must be ENABLED to change the settings manually.

•Mode - Setup Reacted Relay as either

Latched or Transparent Mode:

zLatched – When sensor alarm activated, relay reacted in setup duration.

zTransparent – Relay reacted temporary during sensor alarm activate.

•Duration - Sets the Reacted Relay Time. (5sec~5min or Until key-in)

•Type - Set the Relay Type to either N/O (Normally Open) or N/C (Normally Closed).

•HDD Event - Turns the Alarm ON/OFF when the Hard Drive experiencing problems.

•CH1~8 Alarm - Sends the Alarm Out when an Alarm Event is detected (set to ON/OFF).

•CH 1~8 Video Loss - Sends the Alarm Out when a Video Loss Event is detected (set to ON/OFF).

•CH 1~8 Motion - Sends the Alarm Out when a Motion Event is detected (set to ON/OFF).

•Operation - Enables / Disables the buzzer for selected Event / Alarm types. Set to ENABLE to change the following settings:

•Mode - Set the Reacted Relay to either Latched or Transparent Mode.

•HDD Event - Generates a Buzzer alert when a Hard Drive event occurs (set to ON/OFF).

•Duration - Sets the Buzzer time (5sec ~ 5min or until a user logs into the system).

•Alarm - Generates a Buzzer Alarm when an Alarm Event is detected (set to ON/ OFF).

•Video Loss - Generates a Buzzer Alarm when a Video Loss Event is detected (set to ON/OFF).

•Motion - Generates a Buzzer Alarm when a Motion Event is detected (set to ON/OFF).

46