Advanced Recording

Continuous / Motion Schedule

Sets the Time or Motion recording for each channel (by hour). Select single or multiple time blocks:

•Mouse Control: Click a single block to open the Recording Type Menu. Click and Drag a block of times to configure multiple channels and times at once.

•Remote Control & Front Panel: Navigate to the Channel Block section, and the entire block will be highlighted

with a White outline:

zPress the ENTER button to access the Time Blocks - the first hour on Channel 1 will be highlighted in Yellow.

zNavigate to the desired time block, and press the ENTER button to activate the block - if a single block is desired, press ENTER a second time.

zTo select multiple blocks, use the arrows to drag the cursor until the desired time blocks are selected and press the ENTER key.

Once the desired time(s) have been selected, the Recording Setting menu is displayed.

Select from:

•NONE: Recording is turned OFF.

•CONTINUOUS: Recording is always ON.

•MOTION: Only starts the recording if motion is detected in the selected time interval.

NOTE: This system has an Advanced Recording Feature where BOTH Continuous and Motion can be set to ON at the same time:

zThe system will record continuously, but when motion is detected the system will display a M recording type on the relevant channel.

zThe event will be logged as Motion in the system archive.

zThis is useful in situations where you want to have continuous recording, but wish to have Motion detected for easier event searching.

zIn addition, an e-mail notification can be sent when Motion has been detected.

Select the RETURN button to apply the changes. Once the settings have been adjusted for the hour(s), the changed time block(s) will be shown based on the legend:

Legend:

• None

• Continuous

• Motion

• Continuous & Motion

53