Setting up Remote Viewing - Appendix #3

Network Checklist

The following checklist is provided to assist you in confirming that all steps have been successfully performed during Network Setup. Use this checklist in conjunction with the steps outlined on the following pages.

1. I have the following:

• High Speed Internet

• A Router

• The Ethernet Cable provided with this system

• The System

• A PC with the Remote Access software installed

2.I have confirmed that my System is set to automatically complete my Network settings (DHCP is set to ON):

•Press the SETUP button on the Front Panel -or- Press SETUP on the Remote -or- Right Click on the screen and select the SETUP option.

•Select the System Setup option

•Select the System option

•Select the Network Menu. Confirm that the options for both DHCP and DDNS have checkmarks in the boxes.

3. I have turned off the System, and performed the following:

• Connected the Ethernet Cable to the back of the System

• Connected the other end of the Ethernet Cable to my Router

NOTE: Network Setup will not work if you do not have a router

4.I have found my System Information by either Pressing the ENTER button on the Front Panel -or- Pressing the INFO button on the Remote Control:

• My IP Address is: ________________________________

• My MAC Address is: ______________________________

NOTE: If your IP address is showing as 127.0.0.1, please return to Step 1 and review all menu settings. Check to make sure that your Ethernet cable is properly connected to your Router and System.

79