Lowrance electronic 10764001 manual Restore radar to Factory Default

Models: 10764001

1 127
Download 127 pages 58.64 Kb
Page 94
Image 94

Occasionally false target returns can occur adjacent to strong target returns such as large boats or container ports. This occurs because not all of the transmitted radar energy can be focused into a single beam by the radar antenna, a small amount energy is transmitted in other directions. This energy is referred to as sidelobe energy and occurs in all radar systems.

The returns caused by sidelobes tend to appear as arcs:

When the radar is mounted where there are metallic objects near the radar, sidelobe energy increases because the beam focus is de- graded. The increased sidelobe returns can be eliminated using the Sidelobe Suppression control in the Radar installation menu.

By default this control is set to Auto and normally should not need to be adjusted. However, if there is significant metallic clutter around the radar, sidelobe suppression may need to be increased. The control should be adjusted as follows:

1.Set Radar range to between 1/2 nm to 1 nm and Sidelobe Suppression to Auto.

2.Take the vessel to a location where sidelobe returns are likely to be seen. Typically this would be near a large boat, container port, or metal bridge

3.Traverse the area until the strongest sidelobe returns are seen.

4.Change Auto sidelobe suppression to OFF then select and adjust the sidelobe suppression control until the sidelobe returns are just eliminated. You may need to monitor 5-10 radar sweeps to be sure they have been eliminated.

5.Traverse the area again and readjust if sidelobes returns still occur.

6.Exit the installation menu.

Restore radar to Factory Default

This can be used to revert all user adjustments to factory settings.

92

Radar Lowrance HDS Gen2 Touch

Page 94
Image 94
Lowrance electronic 10764001 manual Restore radar to Factory Default, Returns caused by sidelobes tend to appear as arcs