DFU RC9500 Ver1_2.qxd 5/28/2004 10:33 AM Page 63

Troubleshooting

General Problems

The display is blank

„Tap the screen to make sure the RC9500 is turned on.

„Adjust the screen brightness using the buttons on the left side. (page 17)

„Make sure the battery pack is properly installed. (page 4)

„Recharge the battery pack using the docking station. (page 5)

The display is too light or too dark

„Adjust the screen brightness using the buttons on the left side. (page 17)

The RC9500 shuts itself off

„This is a feature of the RC9500 to save power. You can change the length the RC9500 stays on in the Setup. (page 13)

Devices do not respond to commands from the RC9500

„Make sure the RC9500 is in USE mode. (page 7)

„Make sure the RC9500’s IR sending eye is pointed towards the device you’re operating.

„Check if the Low Battery icon appears. If so, recharge the battery pack using the docking station. (page 5)

„Check if the button you are trying to use is programmed properly. (page 18)

„Check if your device understands these particular Marantz infrared codes. Re-add the device with the correct model number. (page 35)

User Guide

59

Page 63
Image 63
Marantz RC9500 manual Troubleshooting, General Problems