Care & Cleaning, cont.
OVEN WINDOW(S)
TO PROTECT THE OVEN DOOR WINDOW:
1.Do not use abrasive cleaning agents such as steel wool scouring pads or powdered cleaners as they may scratch the glass.
2.Do not hit the glass with pots, pans, furni- ture, toys, or other objects.
3.Do not close the oven door until the oven racks are in place.
Scratching, hitting, jarring or stressing the glass may weaken its structure causing an increased risk of breakage at a later date.
LEVELING LEGS
➢Be sure the
The range should be leveled when installed. If the range is not level, turn the plastic leveling legs, lo- cated at each corner of the range, until range is
level.
BRACKET
LEVELING LEG
UPPER AND LOWER OVEN
LIGHTS (SELECT MODELS)
To assure the proper replacement bulb is used, order bulb from Maytag Customer Service. Call
CAUTION:
➢Disconnect power to range before replacing light bulb.
➢Allow oven to cool before replacing light bulb.
➢Make sure bulb cover and bulb are cool before touching.
TO REPLACE OVEN LIGHT BULB:
1.When oven is cool, use fingertips to grasp edge of bulb cover. Pull out and remove.
2.Carefully remove old bulb by pulling straight out of ceramic base.
3.To avoid damaging or decreasing the life of the new bulb, do not touch the bulb with bare hands or fingers. Hold with a cloth or paper towel. Push new bulb prongs straight into small holes of ceramic base.
LOWER OVEN LIGHT
(SELECT MODELS)
CAUTION:
➢Disconnect power to range before replacing light bulb.
➢Use a dry potholder to prevent pos- sible harm to hands when replacing bulb.
➢Be sure bulb is cool before touching bulb.
➢Do not touch hot bulb with a damp cloth as this may cause the bulb to break.
BULB COVER
WIRE
RETAINER
TO REPLACE OVEN LIGHT BULB:
1. When oven is cool, hold bulb cover in |
place, then slide wire retainer off cover. |
NOTE: Bulb cover will fall if not held in |
CONVENIENCE OUTLET
(CANADIAN MODELS ONLY)
The convenience outlet is located on the lower left side of the backguard.
Be sure appliance cords do not rest on or near the surface element. If the surface element is turned on, the cord and outlet will be damaged.
The convenience outlet circuit breaker may trip if the small appliance plugged into it exceeds 10 amps. To reset the circuit breaker, press the switch located on the lower edge of the back- guard.
4.Replace bulb cover by snapping into place.
5.Reconnect power to the range. Reset clock.
| place while removing wire retainer. |
2. | Remove bulb cover and light bulb. |
3. | Replace with a |
4. | Replace bulb cover and secure with wire |
| retainer. |
5. | Reconnect power to range. Reset clock. |
CIRCUIT BREAKER SWITCH
15
