Mercedes-Benz CS1000 manual 10 DM, DM 8 for “Current”, 9 “Stored” and, 10 “Registered” Fault Codes

￿￿!'￿￿￿￿￿￿￿￿&￿￿￿￿￿￿￿			CS1000 Code Scanner OB15-11
8 -	9 -	10 DM

SEE ME-SFI INJECTION FOR ALL DIAGNOSTIC CODES FROM 8/96 PRODUCTION AND LATER FOR ALL MODELS.

Engines		Model Years
104 119 120		1991-96
Connect wires of Scanner as follows
Scanner	Data Link Connector 16-pin
Yellow	Socket		3
Black	Socket		1
Red	Socket 16
Scanner	Data Link Connector 38-pin
Yellow	Socket 19
Black	Socket		1
Red	Socket 3

DM 8 for “Current”,		9 “Stored” and	10 “Registered” Fault Codes
DTC Readout	Possible Cause of Failure
000	No fault found
002	Oxygen sensor. No signal (right bank in 120)
003	Fuel adaptation (lambda control), inoperative. Engine control module (right bank in 120)
004	Air injection defective, fault from Fuel control system (right bank in 120)
005	EGR exhaust gas recirculation incorrect, fault. Engine control module (right bank in 120)
006	Idle speed control incorrect, fault from EA/CC/ISC
007	Ignition system defective, fault from Fuel/Ignition control system (right bank in 120)
008	Coolant temperature sensor signal. Open or short circuit (right bank in 120)
009	Intake air temperature sensor signal. Open or short circuit (right bank in 120)
010	Air mass sensor voltage signal too high /low. (right bank in 120)
011	Engine speed signal TN (RPM) or Engine control module (right bank in 120) defective
012	Oxygen sensor heater circuit. Open or short circuit (right bank in 120)

131