
Menu item
Eco-Mode
Off
Energy
Paper
Energy/Paper
Quiet Mode
Off
On
Run Initial Setup
Yes
No
Alarm
Cartridge Alarm
Off
Single
Timeouts
Power Saver Disabled
Timeouts
Print Timeout
Disabled
Timeouts
Wait Timeout Disabled
Description
Note: Off is the factory default setting.
Note: Off is the factory default setting.
Before running the Setup Wizard, the default setting is Yes, but after running the wizard, the default setting is No.
The display shows a message when the toner is low
Notes:
•Off is the factory default setting. The Toner is low message will appear as a warning.
•Single means the Toner is low message will appear and the indicator light will blink red.
Sets the amount of time in minutes the printer waits after a job is printed before it goes into a reduced power state
Note: Disabled does not appear unless Energy Conserve is Off.
Sets the amount of time in seconds the printer waits to receive an
Notes:
•90 seconds is the factory default setting.
•When the timer expires, any partially printed page still in the printer is printed, and then the printer checks to see if any new print jobs are waiting.
•Print Timeout is available only when using PCL. This setting has no effect on PostScript emulation print jobs.
Sets the amount of time in seconds the printer waits for additional data before canceling a print job
Notes:
•40 seconds is the factory default setting.
•Wait Timeout is available only when the printer is using PostScript emulation. This setting has no effect on PCL emulation print jobs.
Understanding printer menus
78