Mitsubishi Electronics DX-TL2500U operation manual Initial settings, HDD Setting, Boot UP Delay

Initial settings (continued)

♦HDD SETTING

The HDD SETTING can be set to MIRRORING (simultane- ous recording to the internal HDD and peripheral recording device HDD as a pair), and PARTITION (an independent partition that can be set within the total HDD memory specifi-

cally for ALARM RECORDING). ( see pages 82-84 “MIR- RORING”, “PARTITION”)

<INITIALIZATION>	ARCHIVE•COPY
ID4•ID5
>>HDD SETTING	NORMAL
BOOT UP DELAY	30S
POWER OFF
INITIALIZATION

ALL DATA WILL BE ERASED

WHEN PROCEED INITIALIZATION

♦BOOT UP DELAY

It is necessary to have connected peripheral recording de- vices running before turning on the unit because the unit de- tects peripheral recording devices when the POWER button on the front of the unit is turned on. The detection time of pe- ripheral recording devices by the unit can be delayed before- hand for devices which take a long time to start-up.

Setting of “BOOT UP DELAY” ( default : “30S” )

“10S”, “11S”, • • • • • , “30S”, • • • • • , “58S”, “59S”

Set “BOOT UP DELAY” with enough time to ac- commodate the start-up of peripheral recording devices.

When timer recording is set in the <TIMER PRO- GRAMS SETTINGS> screen, setting the “BOOT UP DELAY ” with 30 seconds or more, the amount of time to exceed 30 seconds in the set-up time of “BOOT UP DELAY” is delayed, and record starts.

1.Turn ON the MAIN switch on the rear of the unit, and wait until the ACCESS indicator goes off. Hold down the REC/STOP button, and press the POWER button on the front of the unit.

•The <INITIALIZATION> screen is appears.

•The POWER button will not respond while the ACCESS indicator is flashing.

2.On the <INITIALIZATION> screen, select “BOOT UP DELAY” by turning the JOG dial, and turn the SHUTTLE ring clockwise.

•The background of the “30S” turns red and flashes.

3.Display the desired time by turning the JOG dial, and turn the SHUTTLE ring clockwise.

•The time is set, and the display stops flashing.

4.Select “POWER OFF” by turning the JOG dial, and turn the SHUTTLE ring clockwise.

•The unit turns off.

5.Press the POWER button on the front of the unit again.

•After the set BOOT UP DELAY transpires, the unit starts detection of peripheral recording devices.

•Confirm that the peripheral recording devices have been detected correctly.

To exit the setting of “BOOT UP DELAY” select the “POWER OFF” so that the data is not erased.• The background of the “ARCHIVE•COPY” turns red and flashes.

••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• Initial settings

23