Scsi connector | Mitsubishi Electronics DX-TL2500U specs

Major operations and their functions (continued)

■ Rear View (continued)
1	2	3																		4		5		6
	ON									CAMERA
	ON
	MAIN
	OFF	IN																								IN
		IN	1	2	3	4	5	6	7	8				9					10	11	12	13	14	15	16	IN
AC IN~		OUT	1	2	3	4	5	6	7	8				9					10	11	12	13	14	15	16	OUT
AC IN~
-240V				OUTPUT A		OUTPUT B																AUDIO		MIC
100																				GND
		T T GND GND R R TRM TRM		REMOTE					ALARM IN	ADJCLOCK	REC EMERGENCY OUTMODE1	OUTMODE2	OUTMODE3	OUTMODE4	OUTMODE5	OUTCALL	OUTCALLGND	GND 30mAMAX	OUT5VDC	RS-232C		ETHERNET		IN
		T T GND GND R R TRM TRM		REMOTE				1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16		ADJCLOCK	REC EMERGENCY OUTMODE1	OUTMODE2	OUTMODE3	OUTMODE4	OUTMODE5	OUTCALL	OUTCALLGND	GND 30mAMAX	OUT5VDC	RS-232C		ETHERNET
		VIDEO		Y/C																		OUT
		VIDEO		Y/C
						RESET																		SCSI
						RESET

RS-485/ RS-422

RECEIVE SEND

REC terminal

Input terminal to start recording. Not available dur- ing timer recording.

EMERGENCY terminal

Input terminal initiating EMERGENCY recording mode.

MODE OUT 1 ~ MODE OUT 5 terminals

Output terminal to indicate the unit’s current mode. Select the unit’s condition by MODE OUT 1 ~ MODE OUT 5 setting in the <REAR TERMINAL SETTINGS> menu.

CALL OUT terminal / CALL OUT GND terminals This is the ISOLATION output terminal. Information that can be transmitted externally consists of CALL OUT settings made on the <REAR TERMINAL SET- TINGS> menu screen as well as fixed output set- tings.

DC 5V OUT terminal

Will only output when both the MAIN switch and POWER button are ON. The maximum electric cur- rent is 30mA.

SEND indicator

Illuminates when the unit is transmitting a signal via the ethernet connection.

16. SCSI connector

This connector is used to connect to peripheral re- cording device (CD-R/RW, tape and HDD’s).

14. RS-232C connector

This connector is used to connect to host device with RS-232C connector. This unit can be controlled by another device through this connector.

15. ETHERNET connector

Use a 10BASE-T cable to connect to the Ethernet terminal. Please use the cable adapted to 10BASE-T. DUPLEX MODE is HALF DUPLEX.

RECEIVE indicator

Illuminates when the unit is receiving a signal via the ethernet connection.

•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••

•••••••••••••

Mitsubishi Electronics DX-TL2500U Scsi connector, RS-232C connector, Ethernet connector

Models: DX-TL2500U