Mitsubishi Electronics DX-TL930E RS-232Csettings / Connecting to a personal computer

■RS-232C settings

This setting can be used for remote device control and recording supplementary information when the main unit is connected to a PC.

♦Transmission speed

Example: Transmission speed is set for 48000 bps.

1.Press the SET UP button to display the <MENU SETTING> menu.

♦Direct connection

Personal Computer

RS-232C crossover cable

Please use RS-232C crossover cable (9pin) to connect a modem with a personal computer. RS -

ENGLISH

2. Turn the JOG dial to move the cursor to REAR TERMINAL			232C Crossover cable differs depending on the per-
then turn the SHUTTLE ring to the right.			sonal computer.

	<REAR TERMINAL>	REC
	@MODE OUT	REC
	CAPACITY REMAIN HDD-10%

	CALL OUT
	BUZZER	KEY
	RS-232C SETTING

3.Turn the JOG dial to move the cursor to RS-232C SETTING and turn the SHUTTLE ring to the right.

•The <RS-232C SETTING> menu will appear.

CALL OUT

BUZZERKEY @RS-232C SETTING

4.Check that the cursor is next to TRANSMISSION RATE and turn the SHUTTLE ring to the right to flash the sub-item.

5.Turn the JOG dial to select “4800” and turn the SHUTTLE ring to the right to finish setting.

6.Press the SET UP button.

•The <RS-232C SETTING> menu will disappear.

■Connecting with a personal computer

This setting can be used for remote device control and recording supplementary information when the main unit is connected to a PC.

Please use RS-232C Straight cable (9pin) to connect a modem with this unit. The setting of CTS

should be set to “HIGH” or “ON”. Please refer to the instruction manual of a modem for details about con- nection.

♦Connection via modem

Personal Comput

	phone line
Modem	Modem

RS-232C straight cable (9 pin)

••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••

Operations