S Y M B O L S E T S / C O D E PA G E S

C

This appendix contains a listing of the symbol sets, code pages, and extended character sets the printers support.

Use the charts in this appendix to convert dot sequences from the image dot pattern to codes you can use in the fields. Use the Binary to Hex Conversion Chart to convert Binary dot sequences to Hexadecimal numbers for bitmap files. Use the Dot to Run Length Encoding Chart to convert dot sequences to alphabetic characters for bitmap files.

S u p p o r t e d S y m b o l S e t s a n d C o d e P a g e s

The printers support these symbol sets and code pages: Internal, ANSI, Bold, OCRA Character Set, DOS Code Page 437 and 850. Additional Code Pages are supported with downloaded TrueType or Double-byte fonts.

The printer defaults to the internal symbol set. See "Defining the System Setup Packet" in Chapter 2 to change the symbol set.

The CG Triumvirate fonts support only the ANSI and DOS Code Page 437 and 850 Symbol Sets. These fonts print a slashed zero when using the ANSI symbol set. However, the scalable font does not print a slashed zero or support Code Page 1256 (Arabic).

Internal

Use this symbol set to print international monetary

 

symbols, the trademark () symbol, and for

 

formats that may be used on other MPCLII

 

printers.

ANSI

Use this symbol set with proportionally spaced

 

fonts.

DOS Code

Use this symbol set for extended and international

Pages 437 or 850

characters with proportionally spaced fonts.

Symbol Sets/Code Pages C-1

Page 237
Image 237
Monarch 9850, 9825, 9403 manual P p o r t e d S y m b o l S e t s a n d code P a g e s, Internal, DOS Code, Pages 437 or