Multiquip FAULTS ANDWARNINGS Auxiliary Gage Fault, DCA-150SSJU3— DIAGNOSTIC DISPLAY, 1800 RPM

DCA-150SSJU3 — DIAGNOSTIC DISPLAY

2.The main menu will pop up on the display.Use the “Arrow Buttons” to scroll through the menu until the “Engine Configuration” menu item has been highlighted.

GO TO 1-UP DISPLAY

STORED CODES

ENGINE CONFG

SETUP 1-UP DISPLAY

SETUP-4-UP DISPLAY

SELECT UNITS

ADJUST BACKLIGHT

3.Once the “Engine Configuration” menu item has been highlighted touch the “Enter Button” to view the engine configuration data.

GO TO 1-UP DISPLAY

STORED CODES

ENGINE CONFG

SETUP 1-UP DISPLAY

SETUP-4-UP DISPLAY

SELECT UNITS

ADJUST BACKLIGHT

FAULTS ANDWARNINGS

Auxiliary Gage Fault

1.During normal operation the single or four parameter screen will be displayed.

				98%	1000 RPM
0	1500		3000
				LOAD RPM	ENG RPM
	1800 RPM
		COOL TEMP		14.2	57 PSI
ENG RPM				BATT VOLT	OIL PRES

2.The PVA Series of auxiliary gages can be attached to the PowerView.These auxiliary gages communicate with the Modbus master PowerView via a daisy-chained RS- 485 port. If at any time during system initialization or normal operation an auxiliary gage should fail, the single or four parameter screen will be replaced with the “MLink Gage Fault” message.

4.Use the “Arrow Buttons” to scroll through the engine configuration data.

1 of x

ENGINE OIL PRESSURE

GAGE NOT RESPONDING

HIDE

ENGINE SPEED PT 1

1800 RPM

MORE

5.Touch the “Menu Button” to return to the main menu.

ENGINE SPEED PT 1

1800 RPM

MORE

6.Touch the “Menu Button” to exit the Main menu and return to the engine parameter display.

3.To acknowledge and “Hide” the fault and return to the single or four parameter display, touch the “Enter Button”.

1 of x

ENGINE OIL PRESSURE

GAGE NOT RESPONDING

HIDE

4.The display will return to the single or four parameter screen.

			!	98%		1000 RPM
0	1500		3000	LOAD RPM		ENG RPM
	1800 RPM				!
				14.2		57 PSI
ENG RPM		COOL TEMP!		BATT VOLT		OIL PRES	!

DCA-150SSJU3— OPERATION AND PARTS MANUAL — REV. #0 (11/14/07) — PAGE 25