Multiquip SP303530, SP303516 Installing and Removing the Blade Guard, Installing the Blade Guard

MQ SP-3035 CONCRETE SAW

Installing and Removing the Blade Guard

Blade Guards for the SP-3035 concrete saw can be installed on either side of the saw.

WARNING

Verify the engine start switch is OFF before installing blade.

Remain clear of all parts of saw while installing blade to prevent crush injury or death.

Installing the Blade Guard

1.Ensure on/off key is off. See Fig. 5 or Fig. 15

2.Slide the Blade Guard Mounting Clip onto the Guard Mounting Tab on the frame.

3.Connect the water delivery hose to the Blade Guard.

4.Ensure that the water tubes are pointed toward the water distribution grooves in the Blade Collars. See Fig. 10

5.Make sure the front-hinged section of the Blade Guard is fully closed before use.

Water Delivery Hose Top Handle

Rear Handle

Blade Guard hinged front

Blade Guard

Mounting Clip

Blade Guard rear section

Fig. 9 — The Blade Guard installed

MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 23