MQ SP-3035 CONCRETE SAW

Stacking Blades for Wide Cuts

WARNING

Remain Clear of all parts of saw while installing blade to prevent crush injury or death.

Verify the engine start switch is OFF before installing blade.

Tighten the 5/8” blade-mounting bolt to 100-125 foot- pounds torque.

Combining (stacking) blades to make wide cuts requires an optional Bushing Extension Kit.

Kit #18502 allows blade stacking from .375” to .75” thickness.

Kit #18501 allows blade stacking from .75” to 1.125” thickness.

1.Ensure on/off switch is off. See Fig. 5 or Fig. 15

2.Remove the existing blade. See Removing the Blade Fig. 7

3.Replace the standard Flange Bushing, Flange Pin, and Mounting Bolt that came with the saw with the longer Bolt, Pin and Bushing which comes with the Kit.

4.Insert the Bushing and Mounting Bolt through the Outer Flange and Blades. The longer bushing and bolt allow blades to be stacked together.

5.Align the Flange Pin through the stack of Blades into the Inner Flange.

6.Tighten the 5/8” Mounting Bolt to 100-125 foot-pounds of torque.

7.Install blade guard.

Inner Collar

Outer Collar

With PinTapered

Blade Shaft

Mounting

Bolt

Collar

Bushing

Fig. 8 — Blade Stacking

MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 22

Page 24
Image 24
Multiquip SP303516, SP303530, SP303526, SP303520 manual Stacking Blades for Wide Cuts, Blade Stacking