Multiquip SP303530, SP303516, SP303526 Lubrication, Grease Fittings and Maximum Cut Depth Stops

MQ SP-3035 CONCRETE SAW

Lubrication

This saw has six grease fittings. Locations are shown in Figure 38 on the front axle assembly, and one, (not shown) on the Jackshaft assembly.

∙Front axle pivot bearings (2)

∙Hydraulic lift cylinder end (1)

∙Depth cylinder pivot bracket (2)

∙Jackshaft pivot (1)

These fittings are easily accessed by raising the saw half way up, and then lifting the rear of the saw until the blade flanges rest on the ground.

WARNING

To prevent the possibility of crush injury, ensure that the saw is securely placed on suitable supports before servicing the lubrication points.

DANGER

Grease each fitting every 25 hours of operation using premium grade waterproof E. P. (extreme pressure) grease.

F1 F2 F3 F4 F5

Maximum Cut		Maximum Cut
Depth Stop Bolt		Depth Stop Bolts
	Fig. 38 — Grease Fittings and Maximum Cut Depth Stops

MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 51