Multiquip SP303526, SP303516, SP303530, SP303520 manual Positraction Adjustment Bolt Locations

MQ SP-3035 CONCRETE SAW

Positraction Adjustment

Clamp Position

(Inner Lip of Drive Hub)

Clamp Position

(Inside Wheel Lip)

Clamp Plate Bolt

	Spacer Position
Clamp Plate Bolt

Fig. 47 — Positraction Adjustment Bolt Locations

1.Lift Saw 4” to 6” and tilt forward to place spindle flanges on ground. When flanges are on the ground, depress Raise Button to raise the rear of the saw to full height. Use suitable stands to hold rear of saw up.

2.Disengage Positraction Lever fully.

3.Loosen Positraction clamping plate bolts enough to adjust Positraction assembly.

4.Insert 1/8” flat spacer between Positraction drive hub and rear wheel on both sides. Use a finger-type clamp to compress the drive hub and the rear wheel, insert spacers between contact points of wheel and hub. Tighten clamp until rear wheel compresses slightly.

5.Tighten Positraction clamping bolts to secure Positraction assembly. Remove clamps and spacer.

6.Remove supports. Grasp the handlebars securely and depress the “Lower” button until the rear of the saw has lowered sufficiently to safely lower the rear wheels to the ground.

MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 60