Multiquip SP303530 Replacing the Spindle Drive Belt, Spindle Drive Belt Adjustment & Replacement

MQ SP-3035 CONCRETE SAW

4.Loosen the Outer Jam Nut on the Single Point Belt Tension Bolt. Turn the Inner Jam Nut counter-clockwise.

5.Adjust drive belt to desired tension. Do Not over tighten.

6.Tighten Engine Mount Lock Bolts.

7.Tighten the Jam Nuts to prevent the Single-Point Bolt from turning.

		Engine Mount
	Inner Jam Nut
		Lock Bolt (1 of 2)
Outer Jam Nut

Spindle Belt

Upper Belt Guard Bolt

Lower Belt Guard Bolts
		Single-Point
		Belt Tension Bolt
	Lower Belt Guard

Fig. 29 — Spindle Drive Belt Adjustment & Replacement

Replacing the Spindle Drive Belt

1.Remove the Upper and Lower Belt Guards. See Figs. 26 & 29.

2.Loosen the Engine Mount Lock Bolts.

3.Loosen the Single-Point Belt-Tensioning Bolt to allow the belt to slip off the engine sheave.

4.Slide the belt off of the engine sheave and pull the belt down around the Spindle sheave.

5.Slide the belt off the top of the Spindle sheave.

6.Reverse steps 1-5 to install a new belt.

MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 43