MQ SP-3035 CONCRETE SAW

Water Supply and Control

 

To prevent damage to the impeller of a belt driven water pump, do

 

not run the engine with the water pump switch on, unless the water

 

supply is connected and water is flowing.

WARNING

When storing the saw during freezing weather, blow out the water

lines to prevent damage to the water delivery system.

 

Connect the job water hose to the water inlet fitting on the left side of the saw.

Verify that the water hose on the saw is connected to the Blade Guard and that the water delivery tubes are pointed into both lower Blade Flanges.

The yellow lever on the control panel regulates water flow volume.

If the saw is equipped with an optional water pump, the ON/OFF switch is on the control panel next to the water flow control valve.

Because of the water delivery efficiency of the 24-port blade flanges, these saws use less water for blade cooling and flushing than other

NOTE saws.

Water Inlet

Flow Control

Lever

 

 

 

Optional

Water Pump

Hose to Blade Guard

Pump

ON/OFF

Switch

Fig. 12 — The Water Supply System

MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 26

Page 28
Image 28
Multiquip SP303516, SP303530, SP303526, SP303520 manual Water Supply and Control, Water Supply System