Multiquip SP303526, SP303516, SP303530, SP303520 manual Spindle Replacement, Engine Mount Lock Bolts

MQ SP-3035 CONCRETE SAW

Spindle Replacement

To assure correct Spindle/Wheel alignment it is recommended that this operation be performed by a Multiquip Authorized Service Center.

DO NOT unbolt the Spindle Mounting Blocks, as they have been factory installed for correct Spindle/wheel alignment.

NOTE

1.Remove the Spindle Drive Belts (see Replacing the Spindle Belt, above).

2.Tighten the Engine Mount Lock Bolts to prevent engine movement during step #3.

Engine Mount

Lock Bolt

Engine Mount

Lock Bolt

Fig. 34 — Engine Mount Lock Bolts

DANGER

To prevent the possibility of crush injury, always ensure that the saw is securely supported whenever it is lifted for maintenance.

3.Block the wheels then lift the saw to the full up position, and block up the front axle to prevent accidental crush injury.

4.Disconnect the two hoses attached to the Spindle, and plug hoses and Spindle ports to prevent drips and dirt contamination.

5.Support the Spindle to prevent tipping or shifting of weight.

6.Unbolt the Spindle Saddle Clamps using a 3/8” Allen wrench.

MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 48