Multiquip SP303516, SP303530 manual Installing the Inner Blade Flange, Installing the Inner Spindle

MQ SP-3035 CONCRETE SAW

DANGER

Ensure the Outer Flange is in place to prevent the Puller and Inner Flange from flying off when the taper breaks loose, and causing injury!

	If the Inner Flange does not readily come free from the tapered
Spindle, lightly tap on the central Puller bolt. This should cause
NOTE	the flange to break free from the shaft.

Installing the Inner Blade Flange

1.Ensure that the tapered portion of the Spindle, and the Inner Spindle are perfectly clean and free of burrs or indentations. Clean and repair as necessary.

2.Ensure that the Drive Key is in place.

3.Slide the Inner Flange onto the tapered portion of the Spindle.

Do Not use any lubricant! Lubricant prevents the tapered surfaces of the Flange and Shaft from mating properly.

NOTE

4.Install the Outer Blade Flange, Flange Bushing, and Mounting Bolt.

5.Tighten with a ½” impact wrench to seat the tapered surfaces of the Inner Flange and Spindle.

Flange Bushing

Outer Flange

Dowel pin

Inner

Drive Key

Spindle

Fig. 32 — Installing the Inner Spindle

MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 46