INSTALLING THE BELT CARTRIDGE

1.Make sure all packing materials and tape are removed from the printer. If you are setting up a 4650NX printer, attach the optional 250-sheet Tray first before installing the Belt Cartridge!

See “Adding the Paper Tray 2 Unit” in Chapter 3.

2.Open the Front Cover of the printer with the Front Cover Release Latch (A).

3.Open the Top Cover of the printer by sliding the Top Cover Release button toward you (B)

4.Flip up the Belt Cartridge Locking Levers inside the top of the printer (C).

AB

5.Remove the Tension Release Pins from both sides of the Belt Cartridge (D). Do not discard these pins.

6.Remove, but do not discard, the black protective sheet from around the Belt Cartridge.

7.Slide the Belt Cartridge into the guides, as shown (E). The flat side of the cartridge should face the front of the printer.

8.Snap the Belt Cartridge Locking Levers into place (F).

9.Close the Top Cover and then the Front Cover of the printer.

note: The Belt Cartridge is sometimes called the Photoconductor Belt Module or OPC Unit.

C

DEF

Save theTension Release Pins and black cover along with all packing materials!

Caution The Belt Cartridge should slide easily into the printer. Do not force it!

16 SuperScript 4650 Series — User’s Guide

Page 22
Image 22
NEC 4650NX manual Installing the Belt Cartridge, See Adding the Paper Tray 2 Unit in Chapter