
Installing DIMM
1.Turn the printer off and disconnect the power cords and all I/O cables.
2.Using a small
(A), and pull out the Controller Board part way (B).
note: You may also perform this procedure with the Controller Board removed. In this case, lay the board down flat.
3.To remove any
4.To add DIMMs:
Hold the DIMM so that the metal connector edge faces
AB
toward the memory socket and the notched side of the DIMM is on the left.
Being careful not to touch the connection points along the edge of the DIMM, insert the DIMM straight into the memory socket (D).
Press the DIMM in until it clicks into place.
Make sure the DIMM is seated securely and the ejector levers are locked.
5.Slide the controller board back into the printer and reinstall the screws (E).
6.Connect the interface cable and power cord and turn on the printer. The Startup page should print indicating the correct amount of RAM (see previous page).
To add or release DIMMs flip open the ejector levers with your thumbs.
Make sure notch is on the left!
CDE