NEC ND-70895 (E) system manual Interrelation among OAI System Commands

COMMANDS

Commands

3.2Outline of Commands for OAI System

The interrelation among the commands to be used in the OAI System is illustrated in Figure 4-2.

	NEAX2400 IMX			External Computer
		IP
	DLC/ELC
AKYD	ASDT	ASYD	Command Name		: Commands for NEAX2400
AOKC
	AKYD	ARNP	ASYD	: Assignment of System Data
AOAC
			ARNP	: Assignment of Reverse Numbering Plan Data
			ASDT	: Assignment of Station Data
			AKYD	: Assignment of DtermKey Data

Figure 4-2 Interrelation among OAI System Commands

AKYD: This command is used to assign the function key codes (For OAI: 34 ~ 47) to the function key positions of the Dterm.

AOKC : This command is used to assign the meaning of OAI key code assigned by AKYD command.

Note 1: Function key codes 34 ~ 47 respectively correspond to OAI key codes (1 ~ 14).

AOAC : This command is used to assign the access code/operation code for the designated facility.

This command is used only when the Facility Kind (F-KIND) has been set to “3” (Open Appli- cation Interface) by AOKC command.

Note 2: Parameters OAI Key Code (KEY-CODE), Facility Kind (F-KIND), and Operation Code (OP-CODE) are determined by the application software to be used at each office.

3.3 Items to Be Explained by Each Command

Each command is described by the following items.

	Command	: The name implies the command and its functions.
(1)	Functions	: This item outlines the command functions.
(2)	Precaution	: This item explains precaution for use of the command.
(3)	Parameters	: This item explains the meaning of the information (parameters) of the data of
		the command.

(4)Related Commands : This item specifies other command or commands pertaining to the same data, assignment/deletion/change/display/list up of the details of that specific data.

CHAPTER 4 ND-70895 (E)

Page 28

Revision 1.0