NETGEAR WAG102NA manual Chapter Management, Remote Management

Chapter 3

Management

This chapter describes how to use the management features of your ProSafe 802.11a/g Dual Band Wireless Access Point WAG102. To access these features, connect to the WAG102 as described in “Logging In Using the Default IP Address” on page 2-11. Then select the category under either the Management or Information headings in the main menu of the browser interface.

Remote Management

SNMP is disabled by default. Enabling SNMP allows for remote management of the WAG102 from a from a client running SNMP Management software.

To set up a Remote Management interface:

1.Under Management on the main menu, select Remote Management. The Remote Management screen will display.

Figure 3-1

2.Enter the following information in the Remote Management fields:

•SNMP: Enable SNMP to allow the SNMP network management software, such as HP OpenView, to manage the wireless access point via SNMPv1/v2 protocol.

3-1

v2.0, September 2006