Nikon WT-3 user manual Connecting to the Computer, PictureProject Version 1.6.1 or Later

Controlling the Camera: PC Mode

In PC mode, a camera equipped with a WT-3 can be controlled over a wireless net- work from a computer running Nikon Capture 4 version 4.4 or later (available sepa- rately) and photographs saved directly to the computer hard disk instead of the camera memory card. The principal steps are:

Connect to the computer	26–27
Control the camera using Nikon Capture 4	28–29

The WT-3 Setup Utility must be installed on the host computer. Before connecting to the host, create a host profi le using the WT-3 Setup Utility ( 11–16) and be sure that the host is running.

Connecting to the Computer

1 To access the network via Ethernet, connect the Ethernet cable (4). Note that wireless transfer is disabled while an Ethernet cable is connected. Dis- connect the Ethernet cable before accessing a wireless network. Turn the camera off before connecting or disconnecting the Ethernet cable.

2 Turn the camera on.

3 Select PC mode for the Wireless transmit- ter > Mode option in the camera setup menu ( 34).

Choose PTP

Before connecting the WT-3, set the USB option in the camera setup menu to PTP ( 11).

PictureProject Version 1.6.1 or Later

In PC mode, PictureProject Transfer can be used to transfer pictures to the computer, where they will be cataloged in the PictureProject software supplied with the camera (version 1.6.1 or later required).

26