Nortel Networks i2022 Series Application, Press MENU, MORE, MORE, Config, MORE, MORE, Spid

i2022 ISDN Teleset

Connecting the I2022- Manual-install

1. Assemble the i2022

NOTE: Make sure the logo plate is installed

2.Verify the PS1/PS2 switch located on the Interface Module is in the PS2 position. See page 6 for further information on setting the PS1/PS2 switch.

3.Verify the Terminating Resistor (TR) switch is set correctly. See page 8 for further information on setting the TR switch.

4.Connect one end of the eight-pin mounting cord to the ISDN Line-In jack on the bottom of the Teleset. Connect the other end of the cord to the S/T jack on your NT1 or ISDN telephone wall jack.

5.Remove the protective film on the display.

6.Label and install the designation card

Manually Choose the Switch Type

NOTE: Your Teleset has a factory default setting of “AUTO” which adjusts to the switch type. An incorrect switch type results in a warning message from the Teleset. The correct switch type, as detected by the Teleset, is displayed as a prompt to change your switch selection.

Manually Entering the SPID

The i2022 supports up to two SPIDs. The two SPIDs are designated

SPID 1 and SPID 2. Both SPIDs can be configured to meet a variety of applications. See Table 4.

APPLICATION

Voice Only

Voice with alternate Analog Port on Call Appearance 1

Voice with alternate Data on Call Appearance 1

Voice with alternate Analog Port and Data on Call Appearance 1

Voice with simultaneous Data

Voice with simultaneous Analog Port

Voice with simultaneous, alternate Data and Analog Port

Voice with alternate analog port and simultaneous Data

Voice with alternate Data and simultaneous analog port

NOTE: POTS is the Analog Port.

Table 4

To change either or both SPIDS:

SPID 1

Voice & <option> Voice & POTS Voice & Data Voice & (P+D) Voice & <option> Voice & <option> Voice & <option> Voice & POTS Voice & Data

SPID 2

NULL

NULL

NULL

NULL

Data

POTS

Data & POTS

Data

POTS

1.Press MENU, MORE, MORE, Config, MORE, MORE, SPID.

2.Select the SPID you wish to change.

3.Press Change if you want to edit the SPID. Pressing Change will not erase the displayed SPID until the new SPID is entered from the keypad. Press Clear if you want to erase the existing SPID.

[Enter the Phone SPID] SPID1 = 84755547360101

Auto Bkspc Save

MORE is flashing

16