Nortel Networks i2022 Series manual AUTO-Switch, Auto-SPID Procedures

i2022 ISDN Teleset

NOTE: You may abort the Auto-Installby pressing the Menu key at any time

The Auto-Installprogramming choices are:

Adjust Contrast – Select Yes or No. The i2022 may display a wait message and start a countdown. This is the T- Wait timer.

NOTE You can abort the T-Wait countdown timer at any time by pressing the Speaker key or any touchtone keypad digit.

SPID – If the switch supports Auto-SPID you will be prompted to choose a SPID. If your switch does not support Auto-SPID, press the “Change” softkey and enter the SPID. After entering the SPID press “Save”.

The Teleset will attempt to initialize. If there is a problem the Teleset will prompt you to correct the SPID and/or switch type.

The Teleset will download its configuration from the switch. If Parameter Downloading is not available, you will be prompted to program the Teleset manually.

Backlight – Select On, Off, or Dynamic. Enter the Date and Time.

Adjust the Ring Pattern – Select Yes or No.

Set the 2nd ring Option – Select Continuous, Partial, or No Ring. Set the Analog Call Appearance.

Set Primary Call Appearances. Set an Intercom Key.

Set Speed Dial Keys.

Set the Alarm Clock. Set a Password. Set Line Preference.

NOTE: Auto-Install will only run when the i2022 is in the default mode.

NOTE: To default the i2022 press MENU and enter 91 from the dial keypad. Press the “YES” softkey to complete the default.

WARNING: DEFAULTING THE i2022 WILL ERASE ALL OF THE MEMORY.

AUTO-Switch

With Auto-Switch detection, the i2022 determines the type of switch to which you are connected. Should you decide to manually program the switch type, Auto-Switch detect will tell you if a different type of switch is found. You will then be given the opportunity to correct the switch type.

AUTO-SPID

Auto-SPID is a National 2 and National 3 ISDN feature. Not all switch types and not all service providers support the Auto- SPID feature. If Auto-SPID is supported, follow the procedure shown below.

Auto-SPID Procedures

When the countdown timer stops, or is aborted, the Teleset automatically sends the Auto-SPID code to the switch. Upon receipt of the Auto-SPID code, the switch will download all of the SPID’s that are supported on that line.

NOTE: If the SPID is not accepted for any reason - including the SPID being used at another location - the phone displays: “Invalid SPID,” and allows correction of the SPID.

14