Nortel Networks i2022 Series manual KEY Clicks, Disable Logging, Testing

i2022 ISDN Teleset

To unprotect the keys, press them again and the key will go dark.

NOTE: Protecting the keys does not prevent Speed dial keys from being changed locally using Menu, SpDial.

KEY CLICKS

Key clicks can be enabled or disabled by pressing MENU, and dialing 96 on the touchtone keypad.

DISABLE LOGGING

Call logs can be disabled completely so that no calls will log, or, they can be disabled so “shared” Call Appearances will not log.

Disabling Call Logs Completely

To disable Call Logging so NO calls will log, press MENU and dial 97 on the touchtone keypad. Press Yes to disable call logging. Press No to enable call logging.

Disable Call Logs On Shared Call Appearance

Call Logs can be disabled on Shared Call Appearances by changing the Shared Call Appearances from Prime Call Appearances to General Call Appearances.

To change Prime Call Appearances to General Call Appearances, press MENU, MORE, MORE, Config, MORE, PrimCA. For further information, see “PrimCA (Primary Call Appearance)”.

NOTE: Remember, changing a Prime CA to a General CA, removes it from the Call Appearances that will be answered by Ringing Line Preference.

TESTING

You can test the operation of your Teleset by using a simple, built-in diagnostic procedure. To begin, follow these steps.

1.Press MENU, MORE, Test

2.Select the test you wish to run.

3.Press the MENU key to exit.

CODE	ERROR TYPE	MEANING
01	RAM Error	Failure in RAM or associated circuits
04	RTC Error	Failure in the clock or associated circuits
08	FLASH Error	Failure in memory or associated circuits
10	S Error	Failure detected on the S Interface
20	E Error	Failure detected on the U Interface
40	F Error	Failure detected in FW Download

“RTC” and an “S Interface” error has occurred in self-test.

54

Error Types have “or bit relation”. This means the code being displayed may be a combination of more than one error code. For example, if the error code displayed is “10”, it would mean an “S-Interface” has error has

occurred in self-test. If the error code displayed is “1C”, it would mean a “Flash”,