Nortel Networks NN43001-307 - page 198

198 Emergency Services conﬁguration

For more information about CLIDVER reports, see Emergency

Services Access Fundamentals (NN43001-613).

6Conﬁgure the branch ofﬁce zone on the main ofﬁce.

a. Conﬁgure the branchofﬁce zone ESA dialing information in LD

117.

LD 117 Conﬁgure branch ofﬁce zone ESA route

Command Description

CHG ZESA <Zone><ESA Route #><AC><ESA Prefix><ESA Locator>

Defines the ESA parameters for the branch office zone, where:

•Zone = Zone number for the branchoffice.

•ESA Route # = Virtual Trunk route to SRG.

•AC = Access Code to add to dialed digits. If no AC is required, enter

AC0 in place of AC1 or AC2.

•ESA Prefix = Digit string added to start of ESDN. This is a unique

prefix in the NRS. Nortel recommends that users use 0 + ESN location

code of the branch office node. An example for location code 725

would be: 0725.

•ESA Locator = Direct Inward Dial telephone number sent as part of

ANI for use by the PSAP to locate the source of the call.

b. Enable the branch ofﬁce zone ESA in LD 117.

ENL ZBR <Zone> ESA

7Conﬁgure the ESA Special Number at the main ofﬁce.

Conﬁgure the ESA Special Number in the NRS. Using NRS,

conﬁgure the ESA Special Number deﬁned for the branch ofﬁce

zone. See IP Peer Networking Installation and Commissioning

(NN43001-313).

Nortel recommends that customers use “0” + the ESN Location code

+ ESDN. An example for location code 725 would be 0725911. The

zero is recommended to prevent a collision in the ESN data with

the HLOC entry.

8Do the following:

a. In LD 86, conﬁgure Emergency Service Access Digit

Manipulation for AC + ESDN dialing to allow recognition of the

ESDN even if AC1or AC2 is used.

Nortel Communication Server 1000

Main Ofﬁce Conﬁguration Guide forSRG 50

NN43001-307 02.02 Standard

Release 5.0 3 December 2007

Copyright© 2005-2007, Nor tel Networks

.

Contents

Main Page Revision history Page Contents New in this release 9 Description 11 Setting up the main ofce 31 Dialing Plan conguration 43 Bandwidth Management 95 Alternative Call Routing for Network Bandwidth Management159 Emergency Services conguration 189 Enhanced UNIStim Firmware Download 205 Appendix A Media Redirection Scenarios 209 List of terms 213 Index 218 Procedures Page New in this release Other Subject Intended audiences Related information NTPs Online CD-ROM Description Contents Survivable Remote Gateway Page Page Main ofce hardware description Signaling Server Network Routing Services Supported IP Phones Main ofce requirements Optional features to enhance SRG functionality Normal Mode and Local Mode overview Normal Mode Local Mode Page Survivability Recovery to Normal Mode Local Mode operation Testing the phone in Local Mode Virtual Trunks IP Phone calls Bandwidth Management Overview Network Bandwidth Management Adaptive Network Bandwidth Management Network Bandwidth Management Zones Time of Day SRG IP Phone to local PSTN calls IP Phone to analog (500/2500-type) telephone calls Conference calls Networking consideration CAUTION Capacity Virtual Trunks capacity Branch ofce dialing plan ESN Access Codes Music on Hold Branch ofce and SRG 50 terminology Limitations Page Setting up the main ofce Introduction SRG information required by the main ofce Main ofce information required by the SRG Page Zone parameters Page Conguring zone parameters using CS 1000 Element Manager Page Branch ofce IP Phone conguration at the main ofce Branch ofce IP Phone conguration using TelephonyManager 3.1 Branch ofce IP Phone conguration using LD 11 SIP IP Trunks conguration at the main ofce Conguring SIP IP Trunks Page Page Dialing Plan conguration Overview On-net dialing plan Page Off-net dialing plan Routing calls SRG user call to an SRG PSTN SRG PSTN to an SRG telephone (DID call) SIP/H.323 zones Zone-based digit manipulation Calling Line ID composition CLID verication Conguring the dialing plan for PSTN access to SRG users in Normal Mode Preparing to congure the dialing plan Conguring the dialing plan Page Page Page Page b. Congure the RLIin LD86 with theRLB feature. For example, assume that the Virtual Trunkis on route 10,and the Customer number is 0: 4Congure ESN Special Number and Digit Manipulation. Page Page Page Page Page Page b. Congure the RLIin LD86 with theRLB feature. For example,assume that the PSTN trunk is on route 18 and the Customer number = 0. 2Congure ESN Special Number and Digit Manipulation. Conguring the dialing plan using CS 1000 Element Manager Testing PSTN access using an SRG IP Phone Dialing plan examples Coordinated Dialing Plan Overview Call scenarios Page Page Page Page Option 1 Page Page Page Page Option 2 Page Local Mode: SRG IP Phones are registered to the SRG. Page Page Page Option 3 Page Local Mode: SRG IP Phones are registered at the SRG. Page Uniform Dialing Plan Overview Call scenarios Page Page Page Conguration examples Tocongure the main ofce: Congure the ESN Control Block for UDP in LD 86. Congure Digit Manipulation (DGT) in LD 86. Congure the UDP Location Code (LOC) in LD 90. Congure the UDP HLOC in LD 90. Congure the HLOC in the Customer Data Block in LD 15. Page Page Page Bandwidth Management Contents Introduction Codec negotiation Page Page Codec selection Codec selection algorithms H.323 Master/Slave algorithm SIP Offer/Answer model Best Bandwidth codec selection algorithm Interoperability between CS 1000 and SRG Conguring Bandwidth Management parameters Zones Conguration rules Network Planning Enabling codecs Conguring Bandwidth Management Conguration using CS 1000 Element Manager Conguration using LD 117 Maintenance commands Maintenance using Element Manager Page Page End Maintenance using LD 117 Adaptive Network Bandwidth Management Description Call scenario Zone bandwidth management and Adaptive Network Bandwidth Management Page Adaptive Network Bandwidth Management conguration parameters Page Limitations Feature packaging Conguration rules Conguring Adaptive Network Bandwidth Management Advanced Conguration Notes Conguration using Element Manager Page Conguration using Command Line Interface Youcan also congure the Adaptive Network Bandwidth Management feature using LD 117. Page Page Page Maintenance commands The Adaptive Network Bandwidth Management feature can be maintained using Element Manager or LD 117. Maintenance using Element Manager End Maintenance using LD 117 The same information can be displayed using commands in LD 117. Page Page Page Tandem Bandwidth Management overview Application Patch Number Dialing Plan Overview Page Network using Uniform Dialing Plan Common details Differences when every branch ofce HLOC is shared with the main ofce Call between two branch ofces associated with the same main ofce Every branch ofce HLOC is shared with the main ofce No branch ofce HLOC is shared with the main ofce, but can be shared with another branch ofce No branch ofce HLOC is shared with the main ofce or another branch ofce Call between branch ofces associated with different main ofce Every branch ofce HLOC is shared with the main ofce No branch ofce HLOC is shared with the main ofce, but can be shared with another branch ofce Page No branch ofce HLOC is shared with the main ofce or another branch ofce Page Summary of provisioning procedures for Tandem Bandwidth Management Provisioning Example of TandemBandwidth Management Page Page Page Page Network using mixed Coordinated Dialing Plan and Uniform Dialing Plan Page Call between two local branch ofces Abnormal case - calls originating using UDP,but terminating using CDP Call between branch ofces associated with different main ofces Page Network using Coordinated Dialing Plan Page Call between two local branch ofces Call between branch ofces associated with different main ofces Page Alternative Call Routing for Network Bandwidth Management Contents Description Page ALTPrex How Alternative Call Routing for NBWM works Call from branch ofce telephone in Normal Mode Call from main ofce telephone to branch ofce telephone Dialing plans Page Page Page A call from a main ofce telephone to a branch ofce telephone Page Page A call from a branch ofce telephone to another branch ofce telephone Page Page Alternative Call Routing for NBWM feature used in All Calls mode Operating parameters Feature interactions Call Redirections Multiple Appearance Directory Number Network Bandwidth Management Network Class of Service Feature packaging Feature implementation using Command Line Interface Task summary list Sample printout Feature implementation using Element Manager Zone conguration Accessing the Zones web page Page Diagnostics Command Line Interface diagnostics Element Manager diagnostics Print zone Alternative Call Routing information Page Page Show the status of the AlternativeCall Routing for NBWM feature Maintenance Command Line Interface Element Manager maintenance Enable branch ofce behavior for a zone Suppress alarms Feature operation Page Emergency Services conguration Overview Emergency Services Access Routing Emergency Services Access (ESA) calls Emergency call routing Conguring ESA for the branch ofce Page Reregistering to minimally congured branch ofce Routing conguration for ESA calls on SRG 50 Determining the dialing plan for ESA calls Page Page Page c. Congure Emergency Service Access call recognition for AC + ESDN dialing in LD 90. Emergency Services for Virtual Ofce Emergency Services while logged in to Virtual Ofce Emergency Services while logged out of Virtual Ofce On-Site Notication Conguring the NRS for ESA SPN Testing the ESDN number Conguring ESA using Element Manager Emergency Service using Special Numbers (SPN) Page Page Enhanced UNIStim Firmware Download Description Firmware upgrade Page Page Appendix A Media Redirection Scenarios Page Page Page List of terms Branch ofce CDP dialing plan DSP Gatekeeper gateway H.323 IP LAN Local Mode Main ofce NCS Normal Mode NRS routing SRG 50 TPS UDP VoIP ZDP Index B C D E O P Q R S Page Page Nortel Communication Server 1000 Main Ofce Conguration Guide for SRG 50