Oki ML590 manual 9D69 QfW, 15 CPI, h”wzk, SI Select Pitch, 10 cpi appears only

57

U	W”	i”
Set-Up (continued)		Operator Panel Function	T	, Limited Operation
		Print Registration	8, 0.05 mm Left, 0.10 mm Left,
			0.15 mm Left, 0.20 mm Left,
			0.25 mm Left, 0.25 mm Right,
			0.20 mm Right, 0.15 mm Right,
			0.10 mm Right, 0.05 mm Right
		Reset Inhibit	d , Yes
		Print Suppress Effective	o” , No
		Auto LF	d , Yes
		Auto CR (appears only when IBM	d , Yes
		Proprinter emulation is selected)
		SI Select Pitch, 10 cpi (appears only	9D69 QfW, 15 CPI
		when IBM Proprinter emulation is
		selected)
		SI Select Pitch, 12 cpi (appears only	:8 QfW, 12 CPI
		when IBM Proprinter emulation is
		selected)
		Time Out Print	lwz , Invalid
		Auto Select	d , Yes
		Ribbon Selection (Optional color	P	, Black, Yellow,
		ribbon must be installed in order to	Magenta, Cyan, Violet, Orange,
		print in colors other than black)	Green
		Printhead Gap Adjust	8, -1, +1
		Graphics Speed	High, b
Parallel I/F		I-Prime	Buffer Print, Buffer Clear, Invalid
		Pin 18	3B , Open
		Auto Feed XT (appears only when	W	, Valid
		Epson LQ emulation is selected)
Serial I/F (appears only when		Parity	d	, Odd, Even
optional Serial Interface is installed)		Serial Data 7/8 Bits	E P	, 7 Bits
		Protocol	h”wz	, X-On/X-Off
		Diagnostic Test	d , Yes
		Baud Rate	19200 bps, FC88 x		, 4800 bps,
			2400 bps, 1200 bps, 600 bps, 300
			bps
		Busy Line	iiR-, SSD+, DTR, RTS
		DSR Signal	lwz , Invalid
		DTR Signal	h”wzk		, Ready on
			Select
		Busy Time	:88	, 1 sec
CSF Bin 1 (appears only with		Line Spacing	C bfW, 8 LPI
optional Cut Sheet Feeder installed)
		Bottom Margin	lwz , Invalid
		Page Width (Model 591 only)	9=6C”, 8.5”
		Page Length	99”, 11-2/3”, 12”, 14”, 17”, 3”,
			3.5”, 4”, 5.5”, 6”, 7”, 8”, 8.5”
		Gap Control	O	, Semi Auto Gap, 1, 2, 3,
			4, 5, 6, 7, 8, 9