2.Uncoil the loop antenna’s braided wire.
3.Flip open the pair of terminal tabs marked AM LOOP on the back of the system, then insert the loop antenna’s bare wires into the ter- minals. Then push the tabs in the opposite direction to lock them.
(illus)
Notes:
•To avoid noise or interference, do not place the loop antenna near a power source or speaker cord.
•For the best reception, install the loop antenna away from any wall.
Connecting the FM Antenna
To connect the supplied FM antenna, flip open the pair of terminal tabs marked FM 300W on the back of the system, and insert the antenna’s bare wires into the terminals. Then push the tabs in the opposite direction to lock them.
(illus)
Extend and position the antenna’s wire for the best reception.
REMOVING THE CD PROTECTION LOCK
The system has a CD protection lock under the system’s base. Installed at the factory, the CD protection lock se- cures the system’s CD changer to pro- tect it from damage during shipping. To use the CD changer, you must re- move the CD protection lock.
(one combined illus for all following steps)
Caution: Be sure the power cord is unplugged from the AC outlet before you begin.
To remove the CD protection lock, turn it in the direction of the arrow until it stops, then pull it out to remove it.Note: Save the CD protection lock so you can use it to secure the system if you move it.
9
